Heat pumps · Error codes · Trianco
Er01Trianco · Activair R32 (S700 / S1200 - FG 9007 / FG 9012)
Er01 on a Trianco Activair R32: Phase dislocation
Short answer
On a Trianco heat pump, Er01 means: Phase dislocation. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Phase dislocation.
Part involved: compressor driver / inverter board.
Likely causes:
- Wrong connection of live wire.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
What you can check
- Note the exact code shown on the controller (a photo helps) and report it to your installer or the manufacturer's service line.
- Check the heat pump's supply breaker/isolator at the consumer unit is on (do not open any casing).
What the engineer will check
- Reverse position of two of the live wires (3-Phase only).
Who to ask for: heat pump electrical / inverter.
Certification: Electrical competence; manufacturer-trained heat pump engineer.
What you might notice
Sources
- Trianco Activair Air Source Heat Pump S700, S1200 - Installation and Service Manual (R32, FG 9007 / FG 9012) ↗ · 2022-04 issue · page 11, 20 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026