F32 on a Panasonic heat pump: Abnormal Internal Thermostat
Short answer
On a Panasonic heat pump, F32 means: Abnormal Internal Thermostat. The heat pump keeps running with some functions stopped. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Abnormal Internal Thermostat.
Part involved: Remote controller (control panel) internal thermostat.
When it shows: - During standby and operation of cooling and heating, control panel thermostat error occur. - When room sensor select use internal thermostat. Service-manual table judgement: Continue for 5 sec. (L, K, J MDC, J MXC, J AIO, H).
Likely causes:
- Abnormality of internal thermostat from R/C 1 or R/C 2. Trigger Conditions: 1 Internal thermostat open circ uit for 5 second continuously detection, R/C display 0°C 2 Internal thermostat short circ uit for 5 second continuously detection, R/C display 0°C 12:00am,Mon Start RC-1 internal thermostat error F32 Close Reset Error code display method Room Temperature will show 0°C on R/C display Internal Thermostat (TH1) 0 32˚c 12:00am,Mon 20˚c˚c.
Is it safe?
| Does the heat pump stop? | Partly |
|---|---|
| Severity | Fault — needs a manual reset once the cause is fixed |
| Engineer needed? | Yes |
The heat pump keeps running with some functions stopped.
Resetting itself: Not stated in the Panasonic documents opened; protection counters lock out after the stated number of occurrences.
Manual reset: User: 'Error Reset' in the remote-controller Quick Menu (H/J/K/L controllers) or OFF/ON; engineer must clear the underlying cause (service manuals: 'When error happens, the power has to be reset').
What you can check
- Read and note the code shown blinking on the remote controller (also stored under System Check > Error history). Per the Panasonic operating instructions the user may switch the system OFF/ON at the remote controller and use 'Error Reset' in the Quick Menu; if the code returns, leave the system and contact the installer (UK user guide lists Panasonic technical support as the fallback).
What the engineer will check
- Check remote controller internal thermostat (open/short circuit gives 0 C display); check wiring; replace remote controller or indoor PCB; check room sensor setting.
Who to ask for: Heat pump installer / commissioning engineer.
Certification: None statutory.
What you might notice
Sources
- Service Manual Hydromodule WH-SDC0509L3E5/L6E5 with WH-WDG05LE5/07LE5/09LE5 (Order No PAPAMY2307068CE) ↗ · PAPAMY2307068CE · page 190 (error codes table) · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026