#15.4 on an Ochsner OTS touch controller alarm platform: Timeout, screed drying program, heating circuit 4 - troubleshooting: Check settings, check heat pump output, shut off building zones if required
Short answer
On an Ochsner heat pump, #15.4 means: Timeout, screed drying program, heating circuit 4 - troubleshooting: Check settings, check heat pump output, shut off building zones if required. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause.
Reviewed 23 September 2026 · 1 source
What it means
The manual says: Timeout, screed drying program, heating circuit 4 - troubleshooting: Check settings, check heat pump output, shut off building zones if required.
Part involved: Timeout, screed drying program, heating circuit 4.
Is it safe?
| Does the heat pump stop? | Not stated |
|---|---|
| Engineer needed? | Yes |
The manual does not say whether the heat pump stops.
Manual reset: Faults are acknowledged via the controller Alarms menu (manual section 22.2).
What you can check
- Note the alarm number and text shown under Menu > Alarms and contact your system installer or OCHSNER customer service.
What the engineer will check
- Check settings, check heat pump output, shut off building zones if required.
Who to ask for: heating installer (OCHSNER system partner).
What you might notice
Sources
- OCHSNER AIR HAWK 208 Operating manual (valid from app V03.03.xxx), incl. OTS fault messages ↗ · EN13 (BA_982010) · page 47 · Reviewed 23 September 2026
A code explains what the controller detected, not a confirmed root cause.
Reviewed: 23 September 2026