SolarpunkHomes
Sign inCall us · +44 7510 081687
Heat pumps
Heat pumps · Error codes · Clivet
P3Clivet

P3 on a Clivet heat pump: Compressor overcurrent protection

Short answer

On a Clivet heat pump, P3 means: Compressor overcurrent protection. The manual does not say whether the heat pump stops. An engineer is needed to fix the cause. The wording differs by model range — each is shown below.

Reviewed 23 September 2026 · 2 sources

What it means

On the Edge EVO 2.0 EXC (WiSAN-YME 1 S)

The manual says: Compressor overcurrent protection.

Likely causes:

  • See Clivet WiSAN-YME manual corrective-action column for this code (not reliably transcribed).

On the Sphera EVO 2.0 (MiSAN-YEE split + SQKN-YEE indoor)

The manual says: Compressor current protection.

Likely causes:

  • See Sphera EVO 2.0 service manual troubleshooting (p.49-105) for this code.

Is it safe?

Switch the heat pump off at its isolator and call an engineer.

Does the heat pump stop?Not stated
SeverityFault — clears by itself when the condition goes
Engineer needed?Yes

The manual does not say whether the heat pump stops.

What you can check

  • Read and note the exact code shown on the controller display.
  • Check the heat pump's breaker/isolator at the consumer unit is on.
  • If the breaker has tripped or trips again, leave the unit off and call an engineer; do not keep resetting it.

What the engineer will check

On the Edge EVO 2.0 EXC (WiSAN-YME 1 S)

  • See Clivet WiSAN-YME manual corrective-action column for this code (not reliably transcribed).

On the Sphera EVO 2.0 (MiSAN-YEE split + SQKN-YEE indoor)

  • See Sphera EVO 2.0 service manual troubleshooting (p.49-105) for this code.

Sources

A code explains what the controller detected, not a confirmed root cause.

Reviewed: 23 September 2026